Matus UHLAR - fantomas wrote:
On 14.06.07 08:20, Ken McCord wrote:
Have an IBM NetVista 6341-64U system (1.0 GHz Celeron, 512 MB RAM,
onboard Intel Ethernet adapter) that when Etch boots on it, will detect
an installed network card, but when networking is configured to start,
will not start it. Here's the output of some commands from a fresh boot:
dmesg | grep eth0
e100: eth0: e100_probe: addr 0xfebff000, irq 5, MAC addr 00:02:55:25:65:FB
ifconfig eth0 up
eth0: ERROR while getting interface flags: No such device
didn't you turn it off in BIOS setup?
Nope, the onboard card is enabled in BIOS. I also receive the same
'eth0: ERROR while getting interface flags: No such device' message when
using PCI cards.
Thanks,
Ken
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
