Is the following line in /etc/network/interfaces :
auto eth0
If not, eth0 will only be brought up when manually instructed to do so
with an ifup command.
----------------------------------------------------------------------
Andrew J Perrin - andrew_perrin (at) unc.edu - http://perrin.socsci.unc.edu
Assistant Professor of Sociology; Book Review Editor, _Social Forces_
University of North Carolina - CB#3210, Chapel Hill, NC 27599-3210 USA
New Book: http://www.press.uchicago.edu/cgi-bin/hfs.cgi/00/178592.ctl
On Fri, 15 Jun 2007, Freddy Freeloader wrote:
The first time I run "/etc/init.d/networking restart" after a reboot I get
the same message I would if I ran "ifdown eth0" about eth0 releasing its dhcp
address, and I no longer have network connectivity, i.e. the
/etc/init.d/networking script does not seem to call ifup -a to restart all
network connections. (I have only one nic on this computer.) To get network
connectivity back I must manually run "ifup etho".
However, ever after that first time event running "/etc/init.d/networking
restart" I get the message "reconfiguring network interfaces" but no ifdown
or ifup messages showing the releasing and acquiring of an ip address through
dhcp. If I run "ifdown eth0" at this point it tells me that eth0 is not
configured, but I have network connectivity and ifconfig -a confirms that
eth0 is configured.
If I run "/etc/init.d/networking stop" I get the correct message that eth0 is
releasing its dhcp address. However, then running "/etc/init.d/networking
start" does not run ifup on eth0 as eth0 remains unconfigured, although I
receive the message that the network interfaces have been successfully
reconfigured. I must manually run ifup eth0 to configure it again and regain
network connectivity.
My question is, is this behavior by design, or have I stumbled across a bug?
I'm running an up-to-date Sid install.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject
of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
