system: etch
I installed a new lan card(Linksys model LNE100TX). The system detected
it and installed the tulip module but the network was not working. I
executed "ifconfig -a" and it showed the new lan card as eth2 ( the mac
address was the new lan card) . It should have been eth0.
/etc/udev/rules.d/z25_persistent-net.rules also showed the new lan card
as eth2 instead of eth0. By switching eth0 and eth2 around I was able to
get the network to work again.
Is this a bug?
Is this the correct way to get my network working again?
Charles
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
