On Tue, May 15, 2007 at 21:53:20 +1000, Robert S wrote: > > It looks like apache and apache-common are not installed automatically. > > Maybe aptitude remembers a previous request you made (even if it was by > > accident). Try to run "aptitude keep-all" and check again with the above > > command. > > > > I could not find this command.
Uh-oh, I forgot to check if it already exists for Sarge's version of aptitude. I think the release notes recommend to upgrade aptitude before upgrading the rest of your system since the new version of aptitude has been improved a lot. > > If you want to upgrade to Etch then you will have to do "dist-upgrade" > > eventually. Read the release notes and follow all the steps, otherwise > > there may be trouble. Also note that there is a section dealing > > specifically with apache (section 5.6). > > > > I repeat: DO NOT just change sources.list and run "aptitude > > dist-upgrade" without reading the release notes. > > I've decided (for better or worse) to go ahead with the "dist-upgrade" and > am following the instructions VERY closely. It looks as if I'm going to end > up with apache and apache2. Not a very good situation, but I'll try to > remove apache afterwards. There might be another posting to this group on > how to remove this properly without a dist-upgrade trying to install it in > the future. It will probably work out OK; if it does not then you know where to find us. Good luck. -- Regards, | http://users.icfo.es/Florian.Kulzer Florian | -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
