Hi Andy. Andy Hawkins, 23.04.2007 13:50: > In article <[EMAIL PROTECTED]>, > Mathias Brodala<[EMAIL PROTECTED]> wrote: >> How do you expect your rule to match these properties? >> >> You say: >> >>> SUBSYSTEMS=3D=3D"scsi" >> But it is 'SUBSYSTEM=3D=3D"block"' instead. > > The bit that contains the 'ZIP 100' is the 'scsi' subsystem, not the 'block' > subsystem.
Oh, yes, my fault.
>> You say:
>>
>>> ATTR{model}=3D=3D"ZIP 100"
>> But it is 'ATTRS{model}=3D=3D"ZIP 100 "' instead.
>
> The udev manual says that trailing whitespace is ignored.
Not fully:
> ATTRS{filename}
> […] Trailing whitespace in the attribute values is
> ignored, if the specified match value does not contain trailing
> whitespace
> itself.
So since ATTRS{model} itself contains whitespace you must specify them in your
rule, too.
>> And besides: you cannot mix properties of two different device sections. =
>> Have a
>> look at how to write udev rules[0] properly.
>
> I don't think I am mixing sections. The 'ZIP 100' string is in the 'scsi'
> section.
I stand corrected now.
Regards, Mathias
--
debian/rules
signature.asc
Description: OpenPGP digital signature
