jjgnu wrote: > I just installed Etch on i386 (previously used Sarge). My printer, > on the parallel port, has stopped working. I'm using LPRng with a > custom print filter that sends lpd output to /dev/lp0. Unfortunately > there is no longer any /dev/lp0, despite parport and parport_pc > modules being loaded. > > Any suggestions how I can get /dev/lp0 back (or failing that, some > other way of sending lpd output to the parallel port)?
Just a wild guess. In Sarge I could not print to /dev/lp0. It appeared that the /dev/lp0 device had not been recognized for some obscure reason, so the output was sent to /dev/other (or something like that), which did not exist. In the KDE printer setup I could set the output device to /dev/lp0, after which it did work. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
