On Thu, 19 Apr 2007, Roberto C. Sánchez wrote:
On Wed, Apr 18, 2007 at 09:18:10PM -0400, Faheem Mitha wrote:
eth0 Link encap:Ethernet HWaddr 00:E0:81:31:33:8C
inet addr:152.3.172.111 Bcast:152.3.173.255 Mask:255.255.254.0
eth1 Link encap:Ethernet HWaddr 00:E0:81:31:33:64
inet addr:152.3.172.60 Bcast:152.3.173.255 Mask:255.255.254.0
You can see here that they are on the same subnet. The problem, as I
mentioned previously, is that having two physical interfaces on the same
subnet can confuse your system quite badly. What is the output of
`/sbin/route -n` ?
/sbin/route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
152.3.172.0 0.0.0.0 255.255.254.0 U 0 0 0 eth1
152.3.172.0 0.0.0.0 255.255.254.0 U 0 0 0 eth0
0.0.0.0 152.3.172.1 0.0.0.0 UG 0 0 0 eth1
Somebody suggested that using two network addresses with one network card
should be possible. Would this make these problems go away?
Thanks. Faheem.
