On 04/17/2007 03:08 PM, Greg Folkert wrote: > On Tue, 2007-04-17 at 12:45 -0400, Ralph Katz wrote: >> No replies? Clear as mud? Let me rephrase my question! :) > > Make sure these check boxes are checked in the admin interface at > http://localhost:631/admin/ > > Share published printers connected to this system > Allow remote administration > Allow users to cancel any job (not just their own) > > Then wait for cups to reload the conf. > > in a few minutes the other machine will notice the proper url fo the > printer and it will be able to work. > > Notice, something changed between Sarge and Etch as far as URLs for the > printers. The Auto config stuff works better than forcing it. > > The only thing is you need to have your machine that has the real > printer... make sure you define everything for it. > > To give you an example, my Epson RX600 was auto-setup properly by my > Etch machine and my sid machine picked it up right away, as soon as I > told my Etch machine to share ...
Works! Thank you, Greg. I didn't trust the web i/f, that was the obvious thing I missed. Regards, Ralph -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
