-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Tommi Lantta wrote: > Hi > > I have a strange display problem after upgrading from Sarge to Etch. > In X the screen is displaced 1 cm to the left (leftmost 1 cm of screen > is out of display area and there is an 1 cm wide black stripe at the > right edge of the display). This only happens with the native 1280x1024 > resolution of the HP 1702 flat panel display. Lower resolutions work > correctly. > > In Sarge I used vesa driver instead of i810, IIRC because the i810 driver > in Sarge didn't support this graphics controller(Intel 82915G/GV/910GL). > I tried using vesa driver now also, but it didn't change anything. > > I tried a Knoppix 5.0.1 CD and it has the same problem with the X > configuration it probes(with vesa driver). Also the system is a dual > boot system and in Windows XP everything works fine, so I'd guess it is > not a hardware problem. Any ideas what is wrong? [snip xorg.conf]
I don't have the same monitor as you do, but I found that pushing the button on my monitor that autosets the display will fix that. Almost all monitors made in the last few years have such a button. Joe - -- Registerd Linux user #443289 at http://counter.li.org/ -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.6 (GNU/Linux) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iD8DBQFGAVgciXBCVWpc5J4RAjOkAKDKtxqy8c3hQQlQd1lAU4MYIQ+eoACfdAI/ PAYVPUwLhpvT0+UmZ2yPEy0= =lv+N -----END PGP SIGNATURE----- -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
