Adam Hardy wrote:
Would it be reasonable to assume that the nvidia driver will run with
a new video card and monitor with 2560 x 1600 resolution? In etch?
I'm not finding the information on nvidia's website, or on the web at
all for that matter.
I am driving the Dell 30" using a eVGA nVidia 7800GT with etch and
nVidia drivers. It works great.
The primary "trick" is to make sure you get a board with at least one
DVI that supports DUAL-LINK DVI. At the time I set this up a lot of
boards had dual DVI but both DVI only supported single-link DVI. To
drive a display 1900x1200 or larger you generally need a DVI port
supporting dual-link DVI (and a dual-link DVI cable).
These days most newer cards support at least one dual-link DVI. Those
based on the nVidia G71 (eg 7900) generally support dual-DVI.
Once I had a dual-link DVI card and the nVidia drivers installed I only
had to tweak the xorg.conf file a bit (mode-line, DPI, and limit
resolutions available to 2560x1600 and 1280x800) to get it work great.
R.Parr, RHCE, Temporal Arts
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
