Hello, i have a new poweredge 1950 with an embedded dell perc 5/i raid controller There are 2 disks in it of 72GB and are configured as RAID 1. I perform a new installation with the debian testing netcd. Everything goes well, netcard is found, DELL Perc is also found. When partioning the HDD in the installation menu, these are the details:
SCSI3 (2,0,0) (SDA) -72.7 GB DELL PERC 5/i i partition the harddisk, continue the installation and install GRUB at the master boot record. I reboot after the installation, the GRUB menu is shown and the system boots. Then after a while i get: ALERT!: /DEV/SDA1 does not exist. Dropping to a shell BusyBox v1.1.3 (Debian 1:1.1.3-2) Built-in shell (ash) enter 'help' for a list of built-in commands. /bin/sh: can't access tty; job control turned off. I also tried in raid 0 without the second disk but it remains the same. It seems that the installation sees SDA1 but it is nog recognized after installation. Can anybody help with this problem please ? thnx, Verus. Disclaimer : This e-mail is intended for the exclusive use by the person(s) mentioned as recipient(s). If you are not the intended recipient, please notify us immediately. This e-mail does not constitute any commitment for Sea-Ro Terminal N.V. or its subsidiaries except when expressly otherwise agreed in a written agreement between the intended recipient and the originating subsidiaries of Sea-Ro Terminal N.V. Sea-Ro Terminal and each of its subsidiaries each reserve the right to monitor all e-mail communications through its networks. This mail has been checked for viruses by Symantec and Trend Micro.
