Debian & Bricolage users: I recently installed Debian Etch (beta 3 release) on a P3/800 machine and installed the Bricolage package (1.8.9-1). Unfortunately, the application seems to run very slowly when I browse to the login page using Internet Explorer (8 to 27+ seconds to load or reload the login page). I get similar results when I run these on a VMware virtual machine. So, I think it's a software issue, not hardware.
"top" shows the CPU loading around 0.20 when I repeatedly reload the home page. I played around with hdparm on the P3/800 machine, but the hard drive seems to perform well with the default settings and there was no apparent change in hard drive read performance or Bricolage performance as I enabled 32-bit mode, etc.. /var/log/bricolage/error.log doesn't show any errors. I suspect something in Bricolage is breaking on Etch and causing time outs, but I don't know how to find or fix the problem(s). Has anyone seen this issue? Is there a way I can enable debugging/ profiling in Bricolage and/or apache-perl to try to figure out what's going on? TIA, David -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
