Hello,
I noticed lately that my sarge box gets quite sluggish if I'm doing lots of
file tranfers. Especially when imaging about 10 workstations at the same time.
In the past, it seemed I could do about 30 without too much slow down.
(done via samba)
I noticed that when I image about 10 stations now, this
migration/0 process goes nuts and takes up about 85-90% CPU.
Plus you get a little lag on the command line.
After the imaging is done, things seem to go back to normal.
Running kernel 2.6.8-smp on a 3.4 Ghz Pentium 4 with HT turned on.
In the past, I had a 3 disk SW raid 5 which seemed to handle the load better.
Now its a 4 disk SW raid 10.
Could that cause the slow down?
What is this migration/0 thing? Haven't noticed it much before.
If I benchmark my array with bonnie on idle, I get about
65 M/sec block writes
25 M/sec rewrites
90 M/sec block reads
I think this is not bad.
Here's top on idle:
Tasks: 166 total, 1 running, 165 sleeping, 0 stopped, 0 zombie
Cpu(s): 0.2% us, 0.2% sy, 0.0% ni, 64.6% id, 0.0% wa, 35.1% hi, 0.0% si
Mem: 2076368k total, 2058184k used, 18184k free, 70280k buffers
Swap: 1044216k total, 808k used, 1043408k free, 1563488k cached
PID USER PR NI VIRT RES SHR S %CPU %MEM TIME+ COMMAND
25237 root 16 0 2068 1112 1852 R 1.0 0.1 0:00.24 top
1 root 16 0 1504 512 1352 S 0.0 0.0 0:00.97 init
2 root RT 0 0 0 0 S 0.0 0.0 126:09.74 migration/0
3 root 34 19 0 0 0 S 0.0 0.0 15:22.99 ksoftirqd/0
4 root RT 0 0 0 0 S 0.0 0.0 0:00.14 migration/1
5 root 34 19 0 0 0 S 0.0 0.0 0:02.20 ksoftirqd/1
6 root 5 -10 0 0 0 S 0.0 0.0 0:04.60 events/0
7 root 5 -10 0 0 0 S 0.0 0.0 0:01.53 events/1
Not sure what else to check for.
Any ideas would be great! Thx,
Cheers,
Mike
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
