Hi, d-u!
When I play a video from the command line (as a user rather than root)
with mplayer, I get the following output:
*****************
MPlayer dev-CVS--3.3.5 (C) 2000-2006 MPlayer Team
CPU: Advanced Micro Devices Duron Morgan,Camaro (Family: 6, Stepping: 0)
MMX2 supported but disabled
3DNow supported but disabled
3DNowExt supported but disabled
CPUflags: MMX: 1 MMX2: 0 3DNow: 0 3DNow2: 0 SSE: 1 SSE2: 0
Compiled for x86 CPU with extensions: MMX SSE
*****************
Is it reporting abut itself? Or what it's detected on the system, e.g.
the kernel's support for the CPU? Or even the CPU itself?
It also complains about not being able to find the joystick and the
infra-red control. I don't have either. I know I can stop it looking
for them with
mplayer -nojoystick -nolirc
but that's a lot of typing. Can I make that the default somehow?
I'd RTFM if I knew where to look and my Google skills seem to have gone
with the heat...
I'm looking at other problems but until I can figure out what's going on
enough to put it into words, I'll hold off on that.
System:
Linux Yewdales-lodge 2.6.8-3-686 #1 Thu May 25 02:27:57 UTC 2006 i686
GNU/Linux
Running Sarge with extras from backports.org and debian-multimedia.org
KDE 3.5.0
Thanks for the help and any further info needed, just ask.
--
Blessings
Wulfmann
Wulf Credo:
Respect the elders. Teach the young. Co-operate with the pack.
Play when you can. Hunt when you must. Rest in between.
Share your affections. Voice your opinion. Leave your Mark.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
