On Mon, May 01, 2006 at 09:29:21PM -0500, Mark Tilford wrote:
> On 4/30/06, James Westby <[EMAIL PROTECTED]> wrote:
> >On (30/04/06 18:35), Mark Tilford wrote:
> >> On 4/29/06, Mark Tilford <[EMAIL PROTECTED]> wrote:
> >> >For various reasons, I had to run the installation on one computer,
> >> >then transfer the hard drive to a different computer. How do I rerun
> >> >the code that autodetects hardware (specifically the netword card)?
> >>
> >> >From bootup:
> >> (DHCP program runs)
> >> eth0: ERROR while getting interface flags: No such device
> >> Bind socket to interface: No such device
> >> exiting.
> >> Failed to bring up eth0.
> >> done.
> >>
> >
> >I think that this means that the name of the interface in
> >/etc/network/interfaces doesn't equal the name of the device on the
> >system.
> >
> >Compare the output of ifconfig with the line auto eth0 or similar in
> >that file.
> >
>
> The /etc/network/devices lines related to eth0 were:
> auto eth0
> iface eth0 inet dhcp
>
> /sbin/ifconfig/eth0 up gives response
> eth0: ERROR while getting interface flags: No such device.
>
> What does this error message mean, and how do I fix it? apt-get is a
> great program, but it's nearly useless until I can get my internet
> connection working.
Try just '/sbin/ifconfig' without the eth0 appended to it. What is the
output of a 'lspci |grep Ethernet'? That should tell you if the new
box' ethernet controller is recognised by the system.
--
Christopher Nelson -- [EMAIL PROTECTED]
-----------------------------------------------------------------------
Little girls, like butterflies, need no excuse.
-- Lazarus Long
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
