How to Configure X

[Joseph Smidt]

I installed Etch, then even tried Unstable and nothing seems to detect my video card.  Someone told my to run dpkg-reconfigure xserver-xorg, but I can't figure out what parameters to put where.  This is my video card info:
Display Size : 15.4" Display Type : Widescreen XGA with TruBrite Technology
Graphics Chipset : Graphics Media Accelerator 950
Graphics Memory : 8MB-128MB dynamically allocated shared graphics memory

my lspci output is:

 
0000:00:02.0 VGA compatible controller: Intel Corporation Mobile Integrated Graphics Controller (rev 03) (prog-if 00 [VGA])
Subsystem: Toshiba America Info Systems: Unknown device ff10
Flags: bus master, fast devsel, latency 0, IRQ 177
Memory at dc100000 (32-bit, non-prefetchable) [size=512K]
I/O ports at 1800 [size=8]
Memory at c0000000 (32-bit, prefetchable) [size=256M]
Memory at dc200000 (32-bit, non-prefetchable) [size=256K]
Capabilities: <available only to root>

0000:00:02.1 Display controller: Intel Corporation Mobile Integrated Graphics Controller (rev 03)
Subsystem: Toshiba America Info Systems: Unknown device ff10
Flags: bus master, fast devsel, latency 0
Memory at dc180000 (32-bit, non-prefetchable) [size=512K]
Capabilities: <available only to root>
                                                         Thanks
--
-------------------------------------------------------------
       Joseph Smidt
     [EMAIL PROTECTED]