Oh, the wlan0's not on there because I did not have the card plugged in. I have already recomplied the modules. I noticed that the eth0 in 2.6.15 does not have an Rx or Tx rate while the eth0 in 2.6.12 does. Once again, I would like to reiterate that the route table for
2.6.15 is empty.
On 2/15/06, jlmb <[EMAIL PROTECTED]> wrote:
> 2.6.15:
> eth0 Link encap:Ethernet HWaddr 00:D0:B7:02:C2:3D
> inet6 addr: fe80::2d0:b7ff:fe02:c23d/64 Scope:Link
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
You need to recompile the ndiswrapper module for the new kernel. I
recommend using package: module-assistant. Note that your wireless
device isn't detected.
As far as eth0, I'm not quite sure what's going on since the device
appears to be working.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
--
Eric Lin
My public key is at www.keyserver.net.
Switch to Dvorak will expire on August 14, 2006
Typed on Dvorak. Switch to the Dvorak
Keyboard Layout. Faster. Easier. Better.
Choose Linux. Always on Target.
