On Wed, Aug 31, 2005 at 11:53:58AM -0500, Matt Zagrabelny wrote: > $ dmesg > usb 1-1: new full speed USB device using uhci_hcd and address 2 > SCSI subsystem initialized > Initializing USB Mass Storage driver... > scsi0 : SCSI emulation for USB Mass Storage devices > usbcore: registered new driver usb-storage > USB Mass Storage support registered. > usb-storage: device found at 2 > usb-storage: waiting for device to settle before scanning > Vendor: Sony Model: Sony DSC Rev: 5.00 > Type: Direct-Access ANSI SCSI revision: 00 > usb-storage: device scan complete > SCSI device sda: 1988608 512-byte hdwr sectors (1018 MB) > sda: Write Protect is off > sda: Mode Sense: 00 00 00 00 > sda: assuming drive cache: write through > SCSI device sda: 1988608 512-byte hdwr sectors (1018 MB) > sda: Write Protect is off > sda: Mode Sense: 00 00 00 00 > sda: assuming drive cache: write through > sda: sda1 > Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
Hello, Thank you for all replies, however I'm afraid you are using the memory which is loaded from the right side (sorry for this not very technical description) into the CF slot. I am using the slot which is loaded from the bottom, there is no memory in the CF slot as the original memory that was there turned out to be defective very quickly, although I was able to mount it as long as it worked. Here is the relevant part of dmesg messages that I'm getting hub.c: new USB device 00:07.2-1, assigned address 2 usb.c: USB device 2 (vend/prod 0x54c/0x10) is not claimed by any active driver. Thanks again for your help Piotr -- Piotr Kopszak, Ph.D. Polish Art Gallery, National Museum in Warsaw -----------------------------> http://kopszak.mnw.art.pl/ http://www.magnatune.com/artists/altri_stromenti -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
