Hi I finally installed Sarge (dual boot with WinXP) on a P4 with an D865GBF Intel Motherboard using packages downloaded from a previous installation on another older PC (via jigdo, which worked fine)
I have a few pending details to adjust, but one of them I eluding me... Post install and with KDE 3.3 up and running fine, I run dpkg-reconfigure xserver-xfree86 to adjust some X settings. The script made a wonderful job at detecting my video and monitor hardware (an On-board AGP with 64Mb and a 15" Phillips) so it proposed itself the right configuration (as I could see becasue the actual names were shown to me); thus, I choosen resolutions higher than 1024x768, which I know the card and monitor handles nicely becasue I use 1152x864 in WinXP and it does work up to 1280x1024 -except that *I* can't read anything there-. I only get at most 1024x768 in KDE 3.3 (and I think in gdm too) (in fact, the pulldown menu shows just up to this resolution) How can I fix this? Related note: I see I have both XF86Config and XF86Config-4.. which one is my system using? How can I tell? Why are there both? TIA Fernando Cacciola -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
