Hi, (I changed the subject so to find it will be more easy for people googleing or the like. I hope)
I have no idea about raid 10, but these are the important things I found about raid on sarge 1) Cheap fake raid cards as Promise (I don't know if this is the case), etc, don't work on 2.6. You could get them working on 2.4, but you'll need to log into 2nd console before partitioning to do modprobe pdcraid in order to get the ataraid device recognized 2) You need to boot from a raid1 partition, say, /boot. Otherwise you'll get grub errors, also probably lilo will fail to boot. 3) Linux swraid is as good as fake hardware raid and a lot more flexible, say, you can set raid1 and raid0 devices, while a fakeraid card tipically lets you only set your disks as raid0 or raid1. So it's better to disable the "raid" feature, usually by changing a jumper on the board. Of course, if you do so, you'll be probably unable to get raid working on windoze Cheers Roman On 7 Jul 2005 06:29:42 -0700 "h2t-nl" <[EMAIL PROTECTED]> wrote: > Hi all, > > Somebody can share his/her experience for Raid10 configuration on > Debian Sarge using e.g. Promise S150 SX4-M or Adaptec 2410SA > controller card. > > Which config is adviseable? Using HW-raid or Linux SW-raid. > > Your feedback will be appreciated. > > Regards, > > Hok Hie > > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact > [EMAIL PROTECTED] > -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
