On Tue, 2002-05-28 at 07:50, Mike Egglestone wrote: > Hi Mark, > Did you install postgres and horde2 from sid? > > mike
Yes, it was sid. I think I understand your problem now, though. I am betting that your hosts file does not say 127.0.0.1 localhost hostname but rather 127.0.0.1 localhost your.network.ip.address hostname This is fine. This is also why using anything but localhost causes failure installing horde. Because as Oliver pointed out, postgres only listens on 127.0.0.1 by default, not whatever your network ip address is. So, your whole problem is likely an imp configuration issue. assuming that you now have a database named horde2, you should be set. (su to root, then su postgres, run psql horde2, and do a \d to get a table listing) >From that point out, it is just a matter of configuring horde/imp properly for database use. I got this going by putting host all 127.0.0.1 255.0.0.0 trust in my pg_hba.conf -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
