hi ya patrick
try using a 2.4.18 kernel w/ raid0/1 built into the kernel
instead of modules..
and/or is that initrd referenced in your lilo.conf for "root" partition
in the lilo.conf stanza
...
root=/dev/md0
initrd=that_one_u_used_from_rescue_partition.gz
c ya
alvin
On Sun, 26 May 2002, Patrick Albuquerque wrote:
> Hi,
>
> I've been struggling to boot into a RAID-1 (mirroring)
>
> o root is hda3, hdc3 as /dev/md0
> o hda3 & hdc3 have partition type 'fd'
> o root is Ext3
> o RAID enabled 2.4.18 kernel
> o initrd has raid modules (added 'raid1' to
> /etc/mkinitrd/modules)
>
> dmesg says:
> Journalled Block Device driver loaded
> md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
> md: raid1 personality registered as nr 3
>
> but boot fails, and I end up in repair mode with hda3 mounted as root
> read-only.
> I can mount /dev/md0 from a rescue partition ok.
>
> Any tips?
>
> patrick
> --
>
>
> --
> To UNSUBSCRIBE, email to [EMAIL PROTECTED]
> with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
>
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
