On Sat, 19 Jan 2002, dman wrote: > On Sat, Jan 19, 2002 at 01:39:56PM -0700, [EMAIL PROTECTED] wrote: > | I'm following the online FAQ on building my own kernel, so far I've dpkg > | --install'd my custom kernel after a make menuconfig, and am now at the > | part where I'm suppose to run /usr/sbin/modconf to setup what modules I > | want to have loaded on boot. But when I tried to run it as root without > | any arguments (to go into GUI mode), all it does is dump me back to the > | shell prompt, and turn the background blue and remove my cursor. Screwing > | up my tty basically, and I can't clear it without a reboot. > > Have you tried typing "reset" or switching to a different tty and > killing the shell on the first?
Didn't know about reset, will use that from now on if I should ever run into the same problem with the terminal again. And yes, I can switch to a different tty, but like I stated, the only way I knew then to clear out that tty was a reboot. > | Or more importantly how to resolve it? Is there another way of > | setting up modules in Debian I should know about besides modconf? > > Use your editor and edit /etc/modules. It is a flat list of modules > names, one per line, of modules you want loaded at boot time. Looking at the date stamp on /etc/modules it's dated to when I first installed Debian. I've compiled the kernel and told it to load a great number of things by module support, this with kernel 2.4.17 (which is different than the 2.2.20 that came with the Debian that I installed.) Am I to assume all modules are named the same between kernel versions? Even one as large as 2.2.x to 2.4.x? And since there's only four lines in /etc/modules, from the 2.2.20 install, where am I suppose to get the module names I had selected to be modules in the 2.4.17 kernel? The documentation on Debian.org recommends that I use modconf. Should I not? And to be honest, I don't remember what all I had selected to be loaded as modules instead of compiled into the kernel during make menuconfig. I find this rather strange that there are a great number of scripts and make targets to handle a kernel build, and even menus to let me select which device to load as modules rather than static, yet when it comes down to it, I'd still have to look up the module names and hand type them into a flat file. If I have to I will, but I just though it strange. Unless there's yet another command besides modconf I'm not aware of? Again, thanks in advance.
