I have an unstable system with a 2.2.19 kernel. I am trying to compile a 2.4.17 kernel, but I get the following error when I run "make-kpkg clean"
claire:/usr/src/linux-2.4.17/linux# make-kpkg clean dpkg: warning, architecture 386-none' not in remapping table rm -f modules/modversions.h modules/ksyms.ver debian/files stamp-build stamp-configure stamp-source stamp-image stamp-headers stamp-src stamp-diff stamp-doc stamp-buildpackage stamp-libc-kheaders stamp-debian test ! -f .config || cp -pf .config config.precious test -f Makefile && make ARCH=i386-none distclean make[1]: Entering directory /usr/src/linux-2.4.17/linux' Makefile:243: arch/i386-none/Makefile: No such file or directory make[1]: *** No rule to make target rch/i386-none/Makefile'. Stop. make[1]: Leaving directory /usr/src/linux-2.4.17/linux' make: [clean] Error 2 (ignored) test ! -f config.precious || mv -f config.precious .config rm -rf debian/tmp-source debian/tmp-headers debian/tmp-image test -f stamp-building || test -f debian/official || rm -rf debian If I run make-kpkg --arch i386 clean, I do not get any error messages, but running "make-kpkg kernel_image" yields these error messages at the end of the compile: make[1]: Entering directory /usr/src/linux-2.4.17/linux' Makefile:243: arch/i386-none/Makefile: No such file or directory make[1]: *** No rule to make target rch/i386-none/Makefile'. Stop. make[1]: Leaving directory /usr/src/linux-2.4.17/linux' make: *** [stamp-build] Error 2 If I run "make-kpkg --arch i386 kernel_image", I get the following error messages at the end of the compile: make[1]: i386-linux-gcc: Command not found make[1]: *** [init/main.o] Error 127 make[1]: Leaving directory /usr/src/linux-2.4.17/linux' make: *** [stamp-build] Error 2 I have searched google and the debian mail archives, but the best answer I could find was to make sure all required packages were up to date. (They are) I think I recall reading about a problem with binutils, but the errors do not seem to be the same as what I am getting. I even found one posting with the same error, but it appears no one had an answer. Thanks in advance for any assistance. -- David Raeker-Jordan mailto:[EMAIL PROTECTED] Harrisburg, PA, USA
