On Thu, Nov 15, 2001 at 01:39:58PM -0800, Adam Shand wrote: > > hey. > > i'm building a debian disk image as a linux based 802.11b access point > (using jouni malinen's host ap mode drivers). basically at this point it > works but i'm trying to convert from lilo to grub because as i become > familiar with it i like it a lot better. > > this image will be batch loaded onto fujitsu stylistic 1000's (which have > a type 3 pcmcia hard drive). so the basic procedure will be: > > * put pcmcia drive in laptop (shows up as /dev/hde) > * cfdisk /dev/hde > * mke2fs /dev/hde1 > * mount /dev/hde1 /mnt > * tar Ixvf image.tar.bz2 /mnt > * install mbr onto drive so it's bootable > > and here's where i get stuck. i can make it work with lilo but i can't > figure out how to do it with grub. can anyone point me in the right > direction please? See man page for grub-install(8) .
Pay special attention to --root-directory=DIR option, since GRUB needs to put
some stuff under DIR/boot .
I hope that helps.
>
> thanks,
> adam.
>
>
> --
> To UNSUBSCRIBE, email to [EMAIL PROTECTED]
> with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
--
GPG key-id: 1024D/DF04A255 Dmitriy
AA16 8FAB 74E1 3511 83D0 9F4B F087 CEC9 DF04 A255
* encrypted personal mail is very much preferred *
Free Dmitry Sklyarov! http://www.freesklyarov.org
pgpf1V6ozO6EZ.pgp
Description: PGP signature
