Hello all, Does any boot parameter or parameters require to boot a kernel successfully when a typical log related to the Hard disk is shown below.
(scsi0) <Adaptec AIC-7896/7 Ultra2 SCSI host adapter> found at PCI 0/12/0 (scsi0) Wide Channel A, SCSI ID=7, 32/255 SCBs (scsi0) Downloading sequencer code... 393 instructions downloaded (scsi1) <Adaptec AIC-7896/7 Ultra2 SCSI host adapter> found at PCI 0/12/1 (scsi1) Wide Channel B, SCSI ID=7, 32/255 SCBs (scsi1) Downloading sequencer code... 393 instructions downloaded scsi: <fdomain> Detection failed (no card) NCR53c406a: no available ports found sym53c416.c: Version 1.0.0 Failed initialization of WD-7000 SCSI card! DC390: 0 adapters found scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.33/3.2.4 <Adaptec AIC-7896/7 Ultra2 SCSI host adapter> scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.33/3.2.4 <Adaptec AIC-7896/7 Ultra2 SCSI host adapter> scsi : 2 hosts. Vendor: SEAGATE Model: ST39175LC Rev: 0001 Type: Direct-Access ANSI SCSI revision: 02 Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 (scsi0:0:0:2) Synchronous at 80.0 Mbyte/sec, offset 15. Vendor: ESG-SHV Model: SCA HSBP M7 Rev: 0.08 Type: Processor ANSI SCSI revision: 02 scsi : detected 1 SCSI disk total. SCSI device sda: hdwr sector= 512 bytes. Sectors= 17783240 [8683 MB] [8.7 GB] -- Jeffrin Jose T. www.MSServices.org GPG:1024D/F5726A1B