I have a Dell Inspiron 7500 with a Xircom CardBus Ethernet 100 + Modem
56 (Ethernet Interface).
I can't get my networt up and running. I have at no time specified
that Debian should use the xirc2ps driver, and I don't know where I do
this.
If I run "/usr/sbin/psnetconfig", it asks me to specify "frame type",
and I don't know what that is.
If I do a "ifconfig eth0", I get this:
eth0 Link encap:Ethernet HWaddr 00:10:A4:B8:5C:61
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:65 errors:1 dropped:0 overruns:0 frame:0
TX packets:50 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0 txqueuelen:100
Interrop:11 Base address:0x400
Is this good or bad?
If I do a "modprobe -l", I get a lot of this:
"/lib/modules/2.2.19pre17/pcmcia/*", including
"/lib/modules/2.2.19pre17/pcmcia/xirc2ps_cs.o".
That's good, right?
Please help me, I'm a newbie and I have no idea on how to fix this.
--
Med venlig hilsen/Best regards,
Søren Neigaard mailto:[EMAIL PROTECTED]
--
"There are two ways to write error-free programs; only the third one works."
