On Sunday 17 June 2001 15:58, Aquila wrote: > You might want to enable the kernel options > > CONFIG_BLK_DEV_IDEDISK > CONFIG_BLK_DEV_IDEPCI > CONFIG_IDEPCI_SHARE_IRQ > CONFIG_BLK_DEV_IDEDMA_PCI > CONFIG_IDEDMA_PCI_AUTO > CONFIG_BLK_DEV_IDEDMA > > Then have a look at your motherboard manual to figure out which specific > IDE controller chipset you have, and enable special support for that. > There is support for most chipsets, and it usually auto detects UDMA > support if you have the right chipset support compiled. Make sure you > are using an 80w IDE cable as well, you need that for UDMA(66). > > You might need the append="idebus=66 ide0=ata66" line in you lilo.conf > (assuming you use lilo and your hdd is on ide0) if it doesn't auto > detect. > > Hope that helps. > > Aq. > Another note: When i start my BIOS says: Primary IDE: No 80 consuctor cable installed. I guess thats it, isn't it... do i have to buy a seperate one?
cheers, Raffaele -- Raffaele Sandrini <[EMAIL PROTECTED]> For encrypted Mail get my Public Key from "search.keyserver.net" ID is: 0xEC4950E9
