Hi I have tried all this and i have enabled USB FS...
Here is a part of my kernel-conf #USB support # CONFIG_USB=m # CONFIG_USB_DEBUG is not set CONFIG_USB_DEVICEFS=y # CONFIG_USB_BANDWIDTH is not set CONFIG_USB_UHCI=m CONFIG_USB_UHCI_ALT=m # CONFIG_USB_OHCI is not set # CONFIG_USB_AUDIO is not set # CONFIG_USB_BLUETOOTH is not set # CONFIG_USB_STORAGE is not set CONFIG_USB_ACM=m # CONFIG_USB_PRINTER is not set # CONFIG_USB_DC2XX is not set # CONFIG_USB_MDC800 is not set # CONFIG_USB_SCANNER is not set # CONFIG_USB_MICROTEK is not set # CONFIG_USB_IBMCAM is not set # CONFIG_USB_OV511 is not set # CONFIG_USB_DSBR is not set # CONFIG_USB_DABUSB is not set # CONFIG_USB_PLUSB is not set # CONFIG_USB_PEGASUS is not set # CONFIG_USB_NET1080 is not set # CONFIG_USB_USS720 is not set # # USB Serial Converter support # # CONFIG_USB_SERIAL is not set # CONFIG_USB_RIO500 is not set And then i enable usb: raffaele:~# modprobe usb-uhci usb.c: registered new driver usbdevfs usb.c: registered new driver hub usb-uhci.c: $Revision: 1.259 $ time 21:22:38 May 23 2001 usb-uhci.c: High bandwidth mode enabled PCI: Found IRQ 11 for device 00:07.2 PCI: The same IRQ used for device 00:0b.0 usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 11 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected raffaele:~# hub.c: USB new device connect on bus1/2, assigned device number 2 usb.c: USB device 2 (vend/prod 0x572/0x1234) is not claimed by any active driver. raffaele:~# modprobe acm usb.c: registered new driver acm As you can see it findes the hub and the device. But /proc/bus/usb ist still empty and the modem gets no power.... HELP cheers, Raffaele > Hey, > > You have enabled 'CONFIG_USB_DEVICEFS' haven't you? Also, if you have VIA > chipset (that's what I have), make sure you're using 'usb-uhci.o', *not* > 'uhci.o' > > Cameron Matheson
