Hey guys. I have a burner that I'm using in Linux via scsi emulation, and a normal ATAPI CD-ROM. Under 2.2.18, by adding
append="hdc=ide-scsi"
to my lilo.conf file, I forced my burner to be handled by the scsi
emulation driver. My cdrom on /dev/hdd was left as an IDE device.
Now, I'm running kernel 2.4.4, with the same config. For some reason
though, the ide-scsi module is grabbing both devices. I want it to just grab
/dev/hdc, and not /dev/hdd. I tried adding
append="hdd=ide-cd"
before the above append line, but that didn't help.
Any ideas?
Thanks,
Mike
--
Michael P. Soulier <[EMAIL PROTECTED]>
"With sufficient thrust, pigs fly just fine. However, this is not necessarily a
good idea. It is hard to be sure where they are going to land, and it could be
dangerous sitting under them as they fly overhead." -- RFC 1925
pgpy7hLttGZcc.pgp
Description: PGP signature
