You shouldn't have to. My /etc/rcS.d (script files that are run at bootup even when going into single user mode) looks like this:
README S30procps.sh S40networking S55bootmisc.sh S05keymaps-lct.sh S30setserial S40pump S55urandom S10checkroot.sh S35devpts.sh S41portmap S70nviboot S15isapnp S35mountall.sh S45mountnfs.sh S20modutils S39dns-clean S48console-screen.sh S30checkfs.sh S40hostname.sh S50hwclock.sh pump runs from here on bootup. You should have an /etc/init.d/pump script that your /etc/rcS.d is linked from. Check to see, otherwise maybe pump isn't installed properly. Check man pump. -Mike -----Original Message----- From: Adam Bender [mailto:[EMAIL PROTECTED] Sent: Wednesday, April 18, 2001 10:44 PM To: debian-user@lists.debian.org Subject: Network card First of all, thanks to everyone who helped me figure out how to get the 3c59x module to work with my 3c950C EtherLink card. It turns out I had the wrong alias for eth0, and I needed to run 'pump' for it to work. My question now is, why do I need to run 'pump' every time I login to get it to work? Is there a better solution than to run it from my .profile on login? Thanks, Adam -- [EMAIL PROTECTED] www.andrew.cmu.edu/~abender Computer scientists have kernel knowledge. -- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
