Funny, I'm using 2.2.12 in my firewall/router, and I didn't do anything
special to get both NICs recognized.
Mike
On Sun, Mar 18, 2001 at 08:13:01PM -0800, Krzys Majewski wrote:
> I've never seen the errors you describe, but I do run 2.2.17 on a
> firewall/router with two NICs. I accomplish this by passing the
> arguments
>
> ether=10,0x300,eth0 ether=3,0x280,eth1
>
> to the kernel.
>
> -chris
>
> Steve Doerr <[EMAIL PROTECTED]> writes:
>
> > Hello.
> > I just rebuilt the 2.2.17 kernel for a firewall/router and got the
> > following errors with my NIC's.
> >
> > /var/log/debug - eth0 no IPv6 routers present
> > /var/log/dmesg - IP-Config: No network devices available
> >
> > lspci -vvb lists both cards and I added the appropriate "append=" line
> > to lilo.conf.
> >
> > I followed the firewall/ethernet howto's about building the kernel for
> > this as best I could (it has changed a little bit). The card support is
> > in the kernel and not a module.
> >
> > Does anyone have any ideas what I overlooked, or what might be wrong?
> >
> > Thanks for any input.
> > Steve
> >
> >
> > --
> > To UNSUBSCRIBE, email to [EMAIL PROTECTED]
> > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
>
>
> --
> To UNSUBSCRIBE, email to [EMAIL PROTECTED]
> with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
>
>
--
Michael P. Soulier <[EMAIL PROTECTED]>
"With sufficient thrust, pigs fly just fine. However, this is not necessarily a
good idea. It is hard to be sure where they are going to land, and it could be
dangerous sitting under them as they fly overhead." -- RFC 1925
