Quoting Stuart Marshall ([EMAIL PROTECTED]):
> sfdisk to partition the new drive;
> mke2fs to make file systems on the new drive;
> mkswap to initialize the swap area on the new drive;
> cd old-partition; find . -mount | cpio -pdm /new-partition
^
For what it's worth, I add "a" so I can still tell which files
I haven't accessed for a long time.
> But then to finish it seems I need to boot the new computer
> (after installing the new drive) with a boot floppy and
> run lilo by hand.
>
> Is there some way to also install the stuff that lilo does
> on the new drive? The new machines will not usually have
> a floppy so I would like to avoid that step.
I won't get a chance to test this until I upgrade another disk,
but you should be able to use the -r option to set the root
partition appropriately for the new drive, and the -C option
to specify a special configuration file. The latter means that
you can write the /etc/lilo.conf on the new disk as it needs to be
in the future system (like you do for /etc/fstab), containing the
future boot= and root= lines, whereas you need to run lilo now on
a file containing boot= and root= with the current device names.
Cheers,
--
Email: [EMAIL PROTECTED] Tel: +44 1908 653 739 Fax: +44 1908 655 151
Snail: David Wright, Earth Science Dept., Milton Keynes, England, MK7 6AA
Disclaimer: These addresses are only for reaching me, and do not signify
official stationery. Views expressed here are either my own or plagiarised.
