can't
you enter the config for the scsi (adapteq is ctrl-q) and assign an IRQ manually
?
You
could also download some tools from 3com, make a dos-boot disk and set the irq
from these disks
good
luck,
J.L.
-----Original Message-----
From: David S. Bach [mailto:[EMAIL PROTECTED]
Sent: Thursday, January 18, 2001 7:45 PM
To: debian-user@lists.debian.org
Subject: 2.2r2 and 3c509 network cardDebian 2.2r2 (kernel 2.2.18pre21) is unable to use the 3c509 ISA network card.In modconf, if I attempt to insert 3c905 modules without parameters,installation fails. In modconf I am apparently able to insert the module using "3c509 io=0210 irq=12." These are the resources used for the card in Win95.lsmod lists 3c509.However, I am unable to configure the card. When I attemptifconfig eth0 192.168.1.6 netmask 255.255.255.0 up, I get the same message twice:SIOCSIFFLAGS: Resource temporarily unavailable.ifconfig -a shows, in addition to the expected:Interrupt: 10 Base address: 0x300(I'm guessing that this is significant since I cannot access devices on the Advansys SCSI PCI card that also claims interrupt 10. What can I do about this?)3c509 shows up in /proc/ioports at 300-30F.It does not show up /proc/interrupts.Help, anyone?TIA,db--
David S. Bach
Seattle, Washington
[EMAIL PROTECTED]
A true person of no rank
