running:
Kernel: 2.2.18pre21
OS: debian 2.2r2
using dialqd/pppd setings from 2.1 setup (which works)
has the follwong uutput:
(from messsages)
Jan 7 10:41:31 zeek2 diald[153]: Calling site 192.168.0.2
Jan 7 10:41:32 zeek2 connect: Initializing Modem
Jan 7 10:41:33 zeek2 connect: Dialing system
Jan 7 10:41:53 zeek2 connect: Connected
Jan 7 10:41:53 zeek2 connect: Loggin in
Jan 7 10:41:53 zeek2 connect: Protocol started
Jan 7 10:41:53 zeek2 diald[153]: Connected to site 192.168.0.2
Jan 7 10:41:53 zeek2 diald[153]: Running pppd (pid = 448).
Jan 7 10:41:54 zeek2 kernel: registered device ppp0
Jan 7 10:41:54 zeek2 pppd[448]: pppd 2.3.11 started by root, uid 0
Jan 7 10:41:54 zeek2 pppd[448]: Using interface ppp0
Jan 7 10:41:54 zeek2 pppd[448]: Connect: ppp0 <--> /dev/ttyS1
Jan 7 10:41:57 zeek2 pppd[448]: Connection terminated.
Jan 7 10:41:57 zeek2 pppd[448]: Connect time 0.1 minutes.
Jan 7 10:41:57 zeek2 pppd[448]: Sent 267 bytes, received 361 bytes.
Jan 7 10:41:57 zeek2 pppd[448]: Exit.
Jan 7 10:41:57 zeek2 diald[153]: start sl0: SIOCSIFMETRIC: Operation not
supported
Jan 7 10:41:57 zeek2 diald[153]: start sl0: SIOCADDRT: File exists
Jan 7 10:41:57 zeek2 diald[153]: start sl0: SIOCADDRT: File exists
Jan 7 10:41:57 zeek2 diald[153]: stop ppp0: Cannot send dump request:
Connection refused
Jan 7 10:41:58 zeek2 diald[153]: start sl0: SIOCSIFMETRIC: Operation not
supported
Jan 7 10:41:58 zeek2 diald[153]: start sl0: SIOCADDRT: File exists
Jan 7 10:41:58 zeek2 diald[153]: start sl0: SIOCADDRT: File exists
Jan 7 10:41:58 zeek2 diald[153]: Disconnected. Call duration 5 seconds.
Jan 7 10:41:58 zeek2 diald[153]: IP transmitted 110 bytes and received 0
bytes.
Jan 7 10:41:59 zeek2 diald[153]: Delaying 2 seconds before clear to dial.
any ideas what is going on, I'm figuring that the sl0 bit is because the ppp
failed, so the problem is with pppd, mabey?
also: mabey its related mabey not, but every time I boot now(since I added
SLIP support to the kernel) the printer starts dumping a page or more of
{z{z{z{z{z{z
I'm using a BJ-200
all of this worked under 2.1 which I am using ot sqend this e-mail.
any ideas?
