Does your kernel have scsi CD-ROM and generic support? I also have an internal scsi CD-ROM and a scsi scanner: my CD-ROM is detected as sr0 and the scanner comes in as sg2 - do you see anything like these being detected later on in dmesg?
Also, ensure that you have scsi termination set on the scanner - this _is_ the only device on the external chain isn't it? LeeE Shawn D'Alimonte wrote: > > I am trying to hook a scanner up to my NCR 3350 using the built in SCSI > controller but the machine is crashing when I try to use it. I tried > searching with Google and Deja but couldn't find anything. > > The machine is: > NCR 3350 (486dx2 upgraded to AMD586, 16MB RAM, MCA bus) > Debian Potato 2.2r1/DRDOS 7.02 (Linux loaded by Loadlin) > Built in NCR53C9x SCSI controller with: > 2 Harddrives, and CDROM internal > HP ScanJet IIp scanner > No ID conflicts, no other SCSI problems. > > When I run find-scanner I get the message "NMI generated from unknown > source!" and the SCSI bus locks up (LED on solid). Does anyone > know what causes this? > > Here is the SCSI info from dmesg: > > SCSI ID 7 Clock 25 MHz CCF=0 Time-Out 167 NCR53C9x(esp236) detected > Adapter found in slot 5: io port 0x240 irq 5 dma channel 3 > scsi0 : NCR 53c9x SCSI > scsi : 1 host. > Vendor: SEAGATE Model: ST31230N Rev: HP04 > Type: Direct-Access ANSI SCSI revision: 02 > Detected scsi disk sda at scsi0, channel 0, id 1, lun 0 > Vendor: CONNER Model: CP30540 545MB3.5 Rev: B0C2 > Type: Direct-Access ANSI SCSI revision: 02 > Detected scsi disk sdb at scsi0, channel 0, id 2, lun 0 > Vendor: HP Model: C1790A Rev: 3226 > Type: Processor ANSI SCSI revision: 02 > Vendor: TOSHIBA Model: CD-ROM XM-3401TA Rev: 2873 > Type: CD-ROM ANSI SCSI revision: 02 > scsi : detected 2 SCSI disks total. > esp0: target 1 [period 200ns offset 15 5.00MHz synchronous SCSI] > SCSI device sda: hdwr sector= 512 bytes. Sectors= 2051460 [1001 MB] > [1.0 GB] > esp0: target 2 [period 200ns offset 15 5.00MHz synchronous SCSI] > SCSI device sdb: hdwr sector= 512 bytes. Sectors= 1045242 [510 MB] [0.5 > GB] > eth0: SMC Ethercard PLUS Elite/A UTP/AUI (WD8013WP/A) found in slot 4 > eth0: Parameters: 0x800, 00 00 C0 DB B9 09, IRQ 10 memory > 0xc0000-0xc3fff. > Partition check: > sda: sda1 sda2 > sdb: sdb1 > > -- > Shawn D'Alimonte [EMAIL PROTECTED] > > -- > Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null
