On Sat, 04 Nov 2000 11:28:28 EST, "Andrew Hagen" writes: >After reading the manual, open a comm program. Programs for these are in the >communications tree of packages. Once you are able to type in "AT" <CR> and >get back "OK", you are communicating with the modem. Then you can alter >the registers and settings of the modem as specified in the manual.
Sometimes it´s also useful to issue a ATI (which gives back some information about the modem), or, if you´re brave ;-) , an AT&F (maybe followed by a 0 or 1) to reset the modem back to factory defaults. hth, &rw -- / Ing. Robert Waldner | Network Engineer | T: +43 1 89933 F: x533 \ \ <[EMAIL PROTECTED]> | KPNQwest/AT | Diefenbachg. 35, A-1150 /
