Hi, Montefin: After run netstat -rn: I get the following information: kernel IP routing table: Destination Gateway Genmask Flags Mss Windows 127.0.0.0 0.0.0.0 255.0.0.0 U 0 o
irtt Iface 0 lo My netrorks card is D-link, but when i install it I use NE2000 compatible to configure it and it works. >From the above information, it seems that I don't give the correct gateway, right? But I have check the "network" at /etc/sysconfig/ I can find the gateway exist there. Any Suggestion? Thanks a lot! Nianwei --- montefin <[EMAIL PROTECTED]> wrote: > Hi Nianwei, > > Ok, then the answer to the first question is no. You > 'activate' eth0. > Save it. Quit the Network Configuration window, > close the control-panel. > But when you go right back it reads 'inactive' > again. Right? > > I don't know if I'll be able to help, but I'll try. > > First, type the following > > netstat -rn > > and hit ENTER. > > Email me back what prints out on the screen. > > Also, let me know what ethernet card and which > driver you have > installed. Ok? > > montefin > > > Nianwei Xing wrote: > > > > Hi, Montefin: > > Thanks for your information. However, after I try > all > > of the things you mentioned. It still doesn't > work. > > Even after I "active" the "eth0" and save and quit > the > > network configuration and when I enter it again, > it > > becomes "inactive" (without boot). I just wonder > that > > whether or not the linux detect my networks card, > > however, I install it through ftp. > > Any suggestion? > > > > Thanks a lot! > > > > Nianwei > > > > --- montefin <[EMAIL PROTECTED]> wrote: > > > > > Nianwei, > > > > > > Sorry, I forgot to mention that in order to > select > > > those two options... > > > > > > 1.) 'Activate interface at boot time.' > > > > > > and > > > > > > 2.) 'Allow any user to (de)activate interface.' > > > > > > You must be in the Network Configuration > > > > Interfaces window AND > > > highlight the interface you want to affect AND > click > > > 'Edit'. That brings > > > up another window called 'Edit Ethernet/Bus > > > Interface' where you will > > > see those 2 options. > > > > > > Then click the 'Done' button in 'Edit > Ethernet/Bus > > > Interface' window, > > > then click the 'Save' button in the Interfaces > > > window. > > > > > > Then click the 'Quit' button and you are > finished. > > > > > > Again, good luck, > > > > > > montefin > > > > __________________________________________________ > > Do You Yahoo!? > > Get Yahoo! Mail - Free email you can access from > anywhere! > > http://mail.yahoo.com/ > > -- > In Life Timing is everything; in Linux Permissions > is everything. > http://www.montefin.com/~montefin/ (up 24/7) > http://finux.com:8080 (our Zope > experiment...evenings & weekends) > http://finux.com:8085 (our XML adventures...evenings > & weekends) __________________________________________________ Do You Yahoo!? Get Yahoo! Mail - Free email you can access from anywhere! http://mail.yahoo.com/
