Thanks to all who responded. I discovered that the Rage128 support in the
XFree86 3.3.6 SVGA xserver does work with this card if you tell it what
the video chipset identification. It appears that the Rage 128 Pro chips
are not properly detected as can be seen in the lines below. I got it to
work by putting the following line in the Device section
ChipId 0x5246
Note that this is not the ChipId reported by /proc/pci. That value
(0x5046) gives the same blank screen.
Perhaps this should be inserted in the xf86config database for the
Rage Fury Pro and the Xpert 2000 Pro which are the cards using the
Rage 128 Pro chip.
Cheers,
Carlo
>> .
>> ((--) SVGA: PCI: ATI Rage 128 PF rev 0, Memory @ 0xe0000000, MMIO @
>> 0xefefc000, I/O @ 0xac00
>> Using XFree86 ATI driver version 4.7.
>> Unknown graphics controller detected.
>> Unknown chip descriptor in BIOS: 0x3F3F0000.
>> Unknown video adapter detected.
>> Brooktree 476 or similar RAMDAC detected.
>> Support for this video adapter is highly experimental!
>>
>> ----- /proc/pci dump -----
>>
>> Bus 1, device 0, function 0:
>> VGA compatible controller: ATI Unknown device (rev 0).
>> Vendor id=1002. Device id=5046.
>> Medium devsel. Fast back-to-back capable. IRQ 11. Master Capable.
>> Latency=64. Min Gnt=8.
>> Prefetchable 32 bit memory at 0xe0000000 [0xe0000008].
>> I/O at 0xac00 [0xac01].
>> Non-prefetchable 32 bit memory at 0xefefc000 [0xefefc000].
>>
--
Carlo U. Segre -- Associate Professor of Physics
Illinois Institute of Technology
Voice: 312.567.3498 Fax: 312.567.3494
[EMAIL PROTECTED] http://www.iit.edu/~segre
