Hello everyone, I have a small problem when switching from X back to a virtual terminal or leaving X completely. The machine boots fine and the monitor frequencies are normal, if I start X, X runs fine, again with expected horizontal and vertical refresh frequencies to the monitor. The problem occurs when switching from X to a virtual terminal or exiting X completely. The horizontal and vertical scan frequencies get set way too high for the monitor and I can't read the display. Does anyone know what X uses to set the card up for a virtual terminal switch or when exiting X? Apart from this everything works fine. This only occured after replacing the motherboard and processor with a much faster one. I was wondering if X read the rdev vga value from the kernel or used the vga line in LILO. Any help would be most appreciated.
Best Regards JohnG 32865e97b5342e762ab140e00f3da23b - Just 'Debian'