On Wed, 05 Apr 2000 16:04:54 PDT, Nick Barron writes: >now they are seperated, but i still can't seem to figure out how to >initialize >eth1 > >i think i might be trying to load module on top of module >loading eth0 instead of eth1 >how is this done effectively?
you can look at the currently loaded modules with lsmod, if ne2k-pci isn´t there yet, ´insmod ne2k-pci´ will (try to) load it. You should then see it via ifconfig, if you don´t, try ´ifconfig -a´. ´ifconfig eth1 x.x.x.x/xx up´ will set the ip-address and netmask. if this works, all you have to do is put ne2k-pci in /etc/modules to get the module loaded at boot time, and edit /etc/init.d/network accordingly to the appropriate ip-addresses. hth, &r<just looking for a 4th nic>w -- / Robert Waldner <[EMAIL PROTECTED]> | Phone: +43 1 89933 0 Fax x533 \ \ KPNQwest/AT tech staff | Diefenbachg. 35 A-1150 Wien /
