On Wed, Feb 16, 2000 at 07:30:02PM -0600, Timothy C. Phan wrote:
> Hi,
>
> I'd like to know what protocol should I put in
> the XF86Config for the Logitech wheel mouse?
>
> I tried the MouseMan protocol and the mouse cursor
> jump/move out of control :(
Section "Pointer"
Protocol "MouseManPlusPS/2"
Device "/dev/mouse"
Resolution 100
Buttons 3
EndSection
...though I do have the problem that the first time I start X, the
middle button (wheel) doesn't work until I launch XF86Setup as root and
twiddle with the mouse driver setting a bit. Seems I need to first set
it to "GlidePoint", then "ThinkingManPS/2" (IIRC), then finally
"MouseManPlusPS/2". It's sufficient to run through the sequence in
XF86Setup and hit "Apply" a couple of times, I don't have to save the
config. Only required on a fresh boot, and only recently (since
Jan/2000?).
--
Karsten M. Self (kmself@ix.netcom.com)
What part of "Gestalt" don't you understand?
SAS for Linux: http://www.netcom.com/~kmself/SAS/SAS4Linux.html
Mailing list: "subscribe sas-linux" to mailto:[EMAIL PROTECTED]
