hello
how can i switch as the default route, between eth0 y ppp0?
is for a machine that need to get access to the net in both ways,
either using the ethernet card or with the modem
the ethernet card is ok, the modem can fax and minicom, i also have
access to the ppp conexion, and i get an IPm but i cannot go any
place, or can not make a ping to any other machine (using ppp)
i have read that i need to switch the default path of route, but m how
can i make it?
i get the following results with ifconfig and route -e
thanks a lot
eth0 Link encap:Ethernet HWaddr 00:E0:7D:76:AA:C2
inet addr:130.149.13.151 Bcast:130.149.13.255 Mask:255.255.254.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:14177 errors:0 dropped:0 overruns:0 frame:4
TX packets:2672 errors:333 dropped:0 overruns:0 carrier:666
collisions:5687 txqueuelen:100
Interrupt:11 Base address:0xe400
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:219 errors:0 dropped:0 overruns:0 frame:0
TX packets:219 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
ppp0 Link encap:Point-to-Point Protocol
inet addr:195.243.107.149 P-t-P:192.168.100.254 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:34 errors:0 dropped:0 overruns:0 frame:0
TX packets:44 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
192.168.100.254 * 255.255.255.255 UH 0 0 0 ppp0
localnet * 255.255.254.0 U 0 0 0 eth0
default gate-12-62.zrz. 0.0.0.0 UG 0 0 0 eth0
