Hi
In one of my most recent attempt's to backup our mailserver i used
afbackup.
I defined a set of 5 tapes but used only 3.
I did a full backup and everything went (apparently) ok.
To test that everything was reaaly ok i did a afverify and it only
complained on the files that had changed size, etc.
To further test i removed a file from my home directory and i tried to
restore it, the problem is that i could figure how i would tell afbackup
to restore that particular file, so i decided to run it in the mode
where it says wich files it would restore under the terms passed as
parameters to it. It started by asking tape number 3 then 2 then 1 then
5 (???). But i don't have nothing on tape 5.
Supposing that my home is /home/sc/mjnf/ and the file is teste.txt how
would i tell afbackup to :
restore the file?
restore the directory?
restore the whole backup?
I've tried reading through the man page but (maybe i'm kinda of dumb) i
coul'nt undertand it.
Thanks
--
Mario Filipe
[EMAIL PROTECTED]
http://neptuno.sc.uevora.pt/~mjnf
