On Fri, 15 Oct, 1999 à 10:45:28PM +0200, Jean-Yves BARBIER wrote:
> Hi all,
>
> I installed a 2.2.12 kernel and the hedridck patch for udma66;
> I had:
> append="mem=127M ide2=0x1e8,0x3ee,11"
>
> in /etc/lilo.conf, but I still have problems; detection is well done
> BUT not for the good drive:
>
> PIIX4: IDE controller on PCI bus 00 dev 39
> PIIX4: not 100% native mode: will probe irqs later
> ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
> ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:pio
> HPT366: onboard version of chipset, pin1=1 pin2=2
> PCI: HPT366: Fixing interrupt 11 pin 2 to ZERO
> HPT366: IDE controller on PCI bus 00 dev 98
> HPT366: not 100% native mode: will probe irqs later
> ide3: BM-DMA at 0xbc00-0xbc07, BIOS settings: hdg:DMA, hdh:pio
> hda: Maxtor 91728D8, ATA DISK drive
> hdc: Maxtor 91080D5, ATA DISK drive
> hdg: IBM-DJNA-351520, ATA DISK drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> ide1 at 0x170-0x177,0x376 on irq 15
> ide3 at 0xb400-0xb407,0xb802 on irq 11
^^^^
BTW, you don't have an ide interface at 0x1e8. As you declare one as ide2 in
your append line, the kernel give ide3 to the interface it detects...
> hda: Maxtor 91728D8, 16479MB w/512kB Cache, CHS=2232/240/63, UDMA(33)
> hdc: Maxtor 91080D5, 10300MB w/512kB Cache, CHS=20928/16/63, UDMA(33)
> hdg: IBM-DJNA-351520, 14664MB w/430kB Cache, CHS=29795/16/63, UDMA(66)
> Floppy drive(s): fd0 is 1.44M
>
> Why does the 3rd HD's on /dev/hdg, instead of /dev/hde?????
Mst Slv
ide0 -> hda, hdb
ide1 -> hdc, hdd
ide2 -> hde, hdf
ide3 -> hdg, hdh
> and why does the speed (hdparm -t ..) still the same than under
> udma33? (and I'm sure that udma66 is Ok on this drive, through the
> dos utility).
>
Wich version of hdparm ? Have you activated udma66 ?
--
( >- Laurent PICOULEAU -< )
/~\ [EMAIL PROTECTED] /~\
| \) Linux : mettez un pingouin dans votre ordinateur ! (/ |
\_|_ Seuls ceux qui ne l'utilisent pas en disent du mal. _|_/
