Doug MacFarlane said:
> Partition check:
> /dev/ide/host0/bus0/target0/lun0: [PTBL] [557/240/63] p1 p2 < p5 >
> /dev/ide/host0/bus0/target1/lun0:hdb: set_multmode: status=0x51 {
> DriveReady SeekComplete Error }
> hdb: set_multmode: error=0x04 { DriveStatusError }
> [PTBL] [1111/240/63] p1 < p5 p6 p7 p8 p9 > p2
> ext3: No journal on filesystem on ide0(3,69)
>
> I have no idea why it's trying to use ext3 and jbd . . .
>
> When I boot 2.2.20, it, ofcourse, is NOT an initrd kernel, and it runs
> fine, and I don't get any of these messages in dmesg . . .
>
> So my workaround will be to recompile the 2.4.29 or 2.4.20 kernel without
> changing the config, and leaving off the --initrd make-kpkg option, and
> editing lilo.conf to remove the initrd option, and see if that fixes it .
I did a search on that error and came up with:
http://dvd.sourceforge.net/xine-howto/en_GB/html/howto-10.html
Using Linux, I get an error which contains status=0x51 { DriveReady
SeekComplete Error }
To fix this error, try enabling `Use multi-mode by default' in your kernel
(re-compile setting ATA/IDE/MFM/RLL support -> IDE, ATA and ATAPI Block
devices -> Use multi-mode by default to `Y'). The relevant piece of kernel
documentation states:
CONFIG_IDEDISK_MULTI_MODE:
If you get this error, try to say Y here:
hda: set_multmode: status=0x51 { DriveReady SeekComplete Error }
hda: set_multmode: error=0x04 { DriveStatusError }
If in doubt, say N.
check /boot/config-`uname -r` for CONFIG_IDEDISK_MULTI_MODE
my redhat 7.3 system has this set to Y, but my custom debian systems
have this set to N ..
not sure what the default is.
changing this may help the other problem(s) as well.
nate
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
