MR wrote: > > /etc/lilo.conf now looks like: > > boot=/dev/hda1 > root=/dev/hda1 > install=/boot/boot.b > map=/boot/map > vga=normal > delay=20 > image=/vmlinuz > label=Linux > read-only > append="ether=11,0x300,eth0 ether=10,0x240,eth1" > > ran liloconfig and let it install a boot block using the current lilo config. > > rebooted.. and only 1 card is picked up (looks like nothing changed) > > -Matt
Make your append entry the first line. I am using two NIC's in this way. You might also try being more ambiguous and let the kernel find the addresses on its own. My lilo.conf looks like this: append = "ether=0,0,eth1" boot=/dev/hda1 root=/dev/hda1 install=/boot/boot.b map=/boot/map vga=normal delay=50 image=/vmlinuz label=Linux read-only #safety net - this is a known working kernel image=/vmlinuz.safe label=safe root=/dev/hda1 vga=normal -- ------------------------------------------------------- Ben Messinger [EMAIL PROTECTED] Only dead fish go with the flow. Use Debian/GNU Linux. -------------------------------------------------------
