Hi all- I ordered the 4 cd set of slink from cheapbytes (and made a $5 donation :). I am trying to install on /dev/sda2 attached to an adaptec 2940uw. There are no ide drives on my computer. I tried booting off the cd, but when it loads the kernel, it gets stuck after finding my scsi card. It stops right after this:
(scsi0) <Adaptec AHA-294X Ultra SCSI host adapter> found at PCI 11/0 (scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs (scsi0) Warning - detected auto-termination (scsi0) Please verify driver detected settings are correct. (scsi0) If not, then please properly set the device termination (scsi0) in the Adaptec SCSI BIOS by hitting CTRL-A when prompted (scsi0) during machine bootup. (scsi0) Cables present (Int-50 YES, Int-68 YES, Ext-68 NO) (scsi0) Downloading sequencer code... 419 instructions downloaded Then it just sits there. I have also tried making the boot floppy (2.1.9-1999-03-03) with the same result. What can I do to install slink? Thanks, Joe
