I just installed dosemu on my system via Debian package (version
0.66.7-13). I need to run a dos program, but I cannot even access the
partition through dosemu.
Thus far, I have tried the following:
- lredir, always fails. Checking deja news, apparently the FreeDOS
does not support this? I keep getting "Error 42 redirecting..."
- mkfatimage16, seg faults. For instance, I tried
"mkfatimage16 -p -f dos_img /the/directory/*" and it just gives me a
Segmentation Fault. Also, I tried _not_ using the -f switch, just
to see if mkfatimage16 gets anywhere, and, in fact, it does write
crud to the screen, but still seg faults after a bit.
- /etc/dosemu/conf modification, doesn't appear to do anything. I use
/dev/sda1 as my Windows/DOS partition, so I tried adding the
following line to my dosemu configuration file:
disk { partition /dev/sda1 }
and nothing happens. I assumed this would appear under the as the
next available drive letter, but I can't get to this data anywhere.
Anyone have any suggestions?
Thanks
Matt
--
Matt Garman, [EMAIL PROTECTED]
"They're always havin' a good time down on the bayou,
Lord, them delta women think the world of me."
-- Dickey Betts, "Ramblin' Man"
