Excellent! That did it. FYI, I couldn't just change the config; I had to remove the module and then add it right back in, changing the parameters at that point.
One more question; after making a change like that, can you get the system to see the change without rebooting? I suspect you can, but I don't know how, so I just rebooted, which worked fine. But I'd like to know for future reference. Thanks again! At 03:38 PM 7/23/1998 -0600, you wrote: >On Thu, 23 Jul 1998, Kent West wrote: > >> I'm sure this is SOMEWHERE in the documentation, but I'm not finding it. >> How do I change the IRQ on my network card in hamm? I've just installed it >> on a laptop/docking station, and forgot to check my IRQ first, so I guessed >> at 10 during the install. That was wrong; I need to change it to 15. How do >> I do this? > >Going into modconf and changing details for the NIC module should allow >you to change the IRQ. Hope this helps. > > > > >-- >Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null > =========================================================== Kent West | Technology Support/Customer Service | Abilene Christian University | Voice: 915-674-2557 FAX: 915.674.6724 | ACU Station, Box 29005 | E-MAIL: [EMAIL PROTECTED] | Abilene, TX 79699-9005 | Ham: KC5ENO, General | =========================================================== -- Unsubscribe? mail -s unsubscribe [EMAIL PROTECTED] < /dev/null
